Measuring Resistance - KPS PA50 MINI Manual De Funcionamiento

Note:
(1) Frequency test range is 10Hz -10kHz. '00.0' will be displayed on LCD if the
test frequency is lower than 10.0 Hz. It is possible to test the frequency which
is higher than 10kHz but the tolerance of the test result can not be ensure.
" means the maximum input voltage is 600V rms AC.
(2) "
Measuring duty:
Beware of Electrocution. Ensure that the test leads are disconnected
from the meter before making current clamp measurements.
1) Set the rotary selector to the A range ( A or A ) position.
2) Press the trigger to open jaw. Fully enclose only one conductor.
3) Press the "Hz/%" to switch to the DUTY measurement.
4) Take the reading on the LCD.
Note: The input signal frequency range is 10 – 1kHz. It is possible to test duty
cycle of the higher than 1 kHz frequency signal, but the tolerance of the test
result can not be ensure.

4.13 Measuring resistance

Beware of Electrocution. When measuring in-circuit resistance, make
sure that the power of the circuit under test has been turned off and
that all capacitors have been fully discharged.
• Plug the black test lead into the COM jack and the red test lead into the
INPUT jack.
• Set the rotary selector to the
AC V range.
• Auto range mode or manual range mode can be selected by pressing the
"RAN" button.
• Connect the test leads to the ends of the resistor or circuit for measurement.
• Take the reading on the LCD.
• NOTE:
1) When the input is open, 'OL' will appear on the LCD to indicate that the
range has been exceeded.
KPS-PA50 MINI • Digital clamp meter
WARNING
WARNING
range position to make the meter get into
44