Environmental Protection; Troubleshooting - GreenWorks Tools 2600807 Manual De Utilización

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
TRANSPORTING THE SNOW SHOVEL
„ Allow the motor to cool down before transporting.
„ Secure the snow shovel while transporting.
„ When moving the snow shovel, grasp it by the top
handle and auxiliary handle.

ENVIRONMENTAL PROTECTION

Do not throw electrical equipment away with
domestic waste. According to the European
Directive 2012/19/ EC on electrical and
electronic equipment waste and its impl
mentation in compliance with national
standards, old electrical equipment must be
collected separately, for ecocompatible
recycling. If electrical equipment is disposed
of in a or in the ground, the harmful
substances can reach the aquifer and enter
the food chain, damaging your health and
PROBLEM
The snow shovel does
not start.
The motor is on, but the
rotor does not turn.
The snow shovel leaves
a thin layer
English (original instructions)

TROUBLESHOOTING

POSSIBLE CAUSE
The battery is not charged.
The lock-out button or
trigger switch were not used
properly.
Battery is too cold.
The battery is not fully
inserted into the housing.
Battery may require service
or replacement.
The belt is damaged.
The scraper is worn.
wellbeing. For further product, contact the
competent authority for the disposal of
domestic waste or your dealer.
At the end of their useful life, discard
batteries with due care for our environment.
The battery contains material which is
hazardous to you and the environment. It
must be removed and disposed of separately
at a facility that accepts lithiumion batteries.
Separate collection of used products and
packaging allows materials to be recycled
and used again. Re-use of recycled materials
helps prevent environmental pollution and
reduces the demand for raw materials.
SOLUTION
Charge the battery by following the
procedures in the battery and charger
manual or refer to this manual.
Press and hold the lock-out button, while
holding the lock-out button, press the switch
trigger.
Remove battery from snow shovel. Place
battery on charger and allow to charge for 10
minutes. Remove from charger and install in
Snow shovel for use.
Check if the battery is fully inserted into the
housing.
Call toll free helpline, at +004922129242919
or replace battery.
Replace the belt (see "IMPELLOR
REPLACEMENT").
Replace the scraper.
6