Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
13
F
G
13. Remove the mounting screw marked with a dot label from the motor assembly (F) and loosen but
do not remove the other 2. Feed the wires from the motor assembly (F) through the center hole in
the light kit housing (G). Position keyhole slots around the screws and twist clockwise. Insert the
screw that you had previously removed. Tighten all screws.
NOTE: In order to prevent damage during shipping,
the motor assembly is secured with four shipping
retainers and screws. You will need to discard these
retainers and screws before install the light kit
housing.
11
Publicidad
Tabla de contenido
