Button Function; Countdown; Turn Signal Switch; Fuel Tank Cap - SHERCO Enduro Manual Del Usuario

2.9 Button function

The function of the button varies depending on the function displayed, as shown
in the table below.
Function
If T≥3" and Speed = 0, the time-setting function is activated
TIME
If T<3" or Speed>0, the functions may be scrolled through
If T≥3" LAP and TD are reset
LAP
If T<3" the functions may be scrolled through
If T≥3" and Speed>0, the circumference, unit of measurement and
TOD
number of impulses per turn of the wheel function is activated
If T<3" or Speed>0, the functions may be scrolled through
If T≥3" LAP and TD are reset
TD
If T<3" the functions may be scrolled through
If T≥3" and Speed>0, the countdown setting function is activated

COUNTDOWN

If T<3" or Speed>0, the functions may be scrolled through
2.10 Initial installation of instrument
The default value of the wheel circumference is 2,091mm, and the unit of measu-
rement is k.p.h. for the speed and kilometres for distance; again by default, the sys-
tem is set to receive 1 impulse for each complete turn of the wheel. To modify any
of these parameters, it is necessary to proceed as per the instructions above.
During the initial installation of the instrument, the display will Visualize the version
and date of the software installed for about 2 seconds.
Immediately after the display's Check, and the visualisation of the pre-set wheel cir-
cumference and number of impulses for each turn of the wheel, the system acti-
vates the standard operating mode.
70
MODE
Left handlebar control switch
1
3
2
4
5
1. Engine stop button
2. Horn button
3. Headlight (high beam)
4. Headlight (low beam)
5. Side lights
E l e c t r i c s t a r t b u t t o n
1
Press on button 1 to start

Turn signal switch

1
1. Right hand turn switch
2. Left hand turn switch
3. Push in to cancel
F u e l t a n k c a p
1
Opening: Turn the cap 1 counterclock-
wise
Closing: Turn the cap 1 clockwise
!
NOTE: Do not fill to the brim as fuel
increases in volume as it gets hotter.
71