Checking Clutch Hydraulic Fluid Level; Topping Off The Clutch Hydraulic Fluid Level - SHERCO Enduro Manual Del Usuario

G
G
E
F
96
- Remove the filter with its housing.
- Separate the filter from its housing.
- Clean the filter foam with a suitable
detergent. (NEUTRAL)
Do not use solvent or petrol !
- Dry the filter element.
- Spray the air filter with
AIR FILTER oil until it achieves a uni-
form blue color.
- Replace the filter element in its housing
with care Make sure that the three lugs
are properly located
- Apply a thin film of
air filter seal.
- If necessary clean the inside of the air
chamber with a cloth.
- Replace the filter and its housing, taking
G
care to centre it correctly.
- Replace the blocking part B (See page 95)
by inserting it first into the filter
assembly and then into the support D
(See page 95).
Replace the seat forwards, making sure that
the recess E is located in the tab F of the
tank and the tongue is under the tank.
Lock the screw by turning it one quarter turn
clockwise.
G
grease to the
!
Warning :
- Hydraulic fluid is highly corrosive, it can de harmful to the skin.
- Please read the recommendations on the container.

Checking clutch hydraulic fluid level

- Place the master cylinder horizontally.
- Check the level through window 1.
1
The level should be between the two arrows
Adjust the level if necessary
Diagram :

Topping off the clutch hydraulic fluid level

- Loosen the two screws 1
1
- Remove the cap 2 and its diaphragm 3
- Fill the reservoir with
2
fluid.
- Replace the diaphragm 3, the cap 2 and
the two screws 1.
3
MIN
DOT 4 brake
97