Emptying, Filling And Bleeding The Cooling; Cleaning The Air Filter - SHERCO Enduro Manual Del Usuario

Emptying, filling and bleeding the cooling system
!
Warning : Make sure that your bike is vertical and on a horizontal surface.
6
7
- Loosen the bleed screw 7 from the cylinder head
- Loosen the bleed screw 4 (See page 93) on the left radiator
Pour new coolant through the radiator filler 5
Radiator Liquid Ref : 500 .
As soon as liquid runs through the screw 7 without bubbles
- Replace the screw with a new washer and tighten to 8 Nm
- Continue filling
Once the level is reached (approx. 1.1 litres)
Put the bike standing on the side stand and recover the operations described
in the previous page.
94
Emptying
- Place a container under the bike
- Remove the cap 5 (See page 93) and the screw 6
- Let the liquid flow out
- Replace the screw 6 with a new washer
- Tighten to 8 Nm
filling

Cleaning the air filter

!
Warning :
The air filter is vital to the correct operation of your bike, so it is important to take
good care of it. A clogged air filter reduces the performance of your bike,
increases fuel consumption and at the worst, dirt can enter into your engine and
cause premature wear and tear.
- To access the air filter:
- Loosen screw 1 on the seat by a quarter turn
counter clockswise.
- Pull the seat back towards the back of the bike.
B
C
Press part B towards the filter C to remove
part B from the electrical component sup-
port D.
1
C
D
95