Checking The Rear Brake Fluid Level; Topping Off The Rear Brake Fluid; Checking The Rear Brake Pads; Removing And Replacing The Front Wheel - SHERCO Enduro Manual Del Usuario

Checking the rear brake fluid level

B
A

Topping off the rear brake fluid

B
if you need to top off the reservoir,
unscrew B and fill with DOT 4
brake fluid. Then re-tighten screw B
86
Use the indicator A to check that the
level is never below the top edge of
the indicator.

Checking the rear brake pads

!
Warning :
Wear on brake pads should be
checked regularly for the sake
of your safety. Under no cir-
cumstances should it be less
than one millimetre thick.
See drawing:
min. thickness
= 1 mm
If you should need to replace it
please approach your

Removing and replacing the front wheel

C
!
Warning : Check that the screws A and C and the nut B are fully
tightened C
- Degrease the disc with
- Prime the brake
NOTE : for torque setting refer to table
dealer.
C A
- To remove the front wheel
- Unscrew the 2 screws A and nut B
- Loosen the two screws C
- Remove the axle from the right side and remove the wheel
- To replace the front wheel - Reverse the procedure.
greasing the axle, with
solvent
B
A
grease.
87