Removing The Headlight Plate; Replacing A Headlight Or Driving Light Bulb; Cooling; Cooling System - SHERCO Enduro Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Removing the headlight plate

The headlight plate can be removed very quickly.
Just unclip the left and right rubbers either side of the forks 1.
1
2

Replacing a headlight or driving light bulb

- Remove the rubber protection A.
- Turn the pin B,
- Withdraw the headlight unit.
- Press lightly on the bayonet bulb, and turn counter clockwise to remove.
- Reverse the procedure to re-assemble.
- The drinving light C is easily replaced by removing the bulb holder from the
reflector.
!
Warning :
- Always use bulbs with the right wattage.
92
1
Release the headlight plate upwards.
Reassembling the headlight plate
Reverse the removal procedure.
Make sure that the lugs 1 on the headlight
plate are securely in the holes 2 in the
front mud guard.
B
A
!
Warning :
With the engine cold check the cooling fluid level and top up if necessary.
Do not check when the engine is hot as the hot liquid can cause severe injuries.
- Cooling liquid is poisonous:
In the event of contact with the skin or the eyes, or ingestion, or injuries
caused by hot liquid: CONSULT A DOCTOR
- Use protective gloves.
- Use cooling liquid
- Always use pre-mixed coolant.
NOTE : To protect the environment, deposit your purged liquid at a collection
center.
Left hand side
4
1
3
2
Right hand side
C
Diagram :
Refill
On bike stand

Cooling

Radiator Liquid Ref: 500

Cooling system:

1 Thermostat
2 Pump
3 Radiator
4 Radiator bleed screw
Checking the level:
Make sure that your bike is
vertical and on a horizontal surface.
Remove the radiator cap 5
- Check that the cooling liquid level is
approximately 10mm above the radiator
tubes.
5
To top up the coolant:
- Place the bike on the side stand
- Loosen the bleed screw 4
- Adjust the level
- Replace screw 4
- Tighten (see torque table)
- Replace the cap 5 and make sure it is
seated correctly
Control
!
Warning : It is extremely important
to follow tuese instructions carefully.
10 mm
Incorrect coolant levels can cause serious
damage to tue engine.
Horizontal
93

Publicidad

Tabla de contenido
loading

Tabla de contenido