Pre-Load Adjustment Of The Rear Shock Absorber Spring; Checking Play In Link Rods; Drive Chain Tension; Drive Chain Adjustment - SHERCO Enduro Manual Del Usuario

Pre-load adjustment of the rear
shock absorber spring
2
To adjust the rear shock absorber spring pre-load,
loosen bolt 1, then turn bolt 2, re-tighten 1

Checking play in link rods

With the bike supported by a suitable
stand, press the top and bottom of the
back wheel. If any play is found, please
contact your
!
Warning : When cleaning with a high pressure jet, never direct the
jet directly on the dust seal.
82
1
dealer.

Drive chain tension

Set the bike on a suitable stand so the
the rear wheel is off of the ground.

Drive chain adjustment

D
B
C
To adjust the chain tension, you should loosen bolts A and B and then loosen the screws
C until the chain is correctly tensioned. Check the symmetry on either side of the
arm using the marks D. Tighten the bolts B and tighten the bolt A.
The sliding part is designed to adapt to the longest chains by turning it
through 180°.
LIft the chain as shown.
The chain slack should be 50mm (2
inches) when measured perpendicular
to the swing arm as shown. If it is
greater or less than this dimension
then the chain tension should be
adjusted.
!
Warning : Poorly adjusted chain
tension can lead to mechanical damage.
D C
A
B
83