Programming Procedure; Check Selection - FAS International JUST NOW Manual Del Usuario

Idiomas disponibles

JUST NOW – Issue 00

Once the installation procedure is terminated, open the door and hold down the "TEST" button on the main

board for approx. 3 sec., until a buzzer emits a prolonged sound. This indicates that you have entered

programming mode and the text "Comando 00" appears on the display.

To Enter a Command, press the corresponding command on the selection panel and press the button

ENTER to confirm the selection. Push-button ENTER is used also to confirm the inserted board-data and to

store them. In this case on the display appears for a few seconds the message "OK". To leave programming

mode or to pass from a submenu to the main menu press A.

Caution: if push button "TEST" is released before the required time the vending machine enters the "check

selection" mode described below. If so, exit this mode by pressing the push button "TEST" once again, then

repeat the operations required to access the programming mode.

Every time the door opens, the selections, if present, that are out of service or not in "home position" (having

executed a quarter turn) will appear on the display (see Command 76). The selections can be reset (by

rotating them) by pressing button "#" (ENTER). If the door is closed again without having reset all the

selections, the event is recorded as an error displayed in Command 99 with code number 91.

ATTENTION: Rotating the selection to reset it with the door open could cause the product to fall to

the ground.

10.1

It is also possible to carry out a function test of the machine by pressing the pushbutton TEST placed on the

main card. The message "SELECTIONS OK" will appear on the display. As an alternative an indication (ex.

12, 14...) could appear to indicate that an irregularity has taken place during the functioning and the spirals

indicated are out of service. Carry out the selection shown on the display to reset. If a working mistake

happens during the test, the tag of the spiral will stay on the display; otherwise the test will go on to the next

out-of-work spiral. If all the selections are all right the corresponding message will appear on the display.

It is possible to test all the selections typing in the corresponding tag. After having finished the test press

again the push-button test on the main card to go back to normal working.

N.B.: To avoid errors the machine returns automatically to normal work after about 1 minute from the

access to test mode, during which no operation is carried out.

If during the test or the reset there should happen some errors, it means that the anomaly is not occasional

but could result from the breakage of some parts and a technical intervention is required.

FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it

PROGRAMMING PROCEDURE

Tabla de Contenido