Publicidad
Idiomas disponibles
Idiomas disponibles
22
10.4 TO SET REFRIGERATION PARAMETERS
Command 41 Sets cabinet temperature:
This command sets the lower internal cabinet temperature of the machine, i.e. the temperature below which
the compressor is turned off. The preset value is +3°C. This value can be varied between +3°C to +25°C.
Command 44 Sets defrost cycle frequency:
This command sets the interval between defrost cycles expressed in hours. This value can be varied from 1h
and 8h and is preset at 4h.
Command 45 Setting the cut-out duration for the refrigeration safety device:
This command sets the amount of time that the refrigeration safety device is to remain disabled. This period
of time prevents the vending machine from shutting down following an operation that involves having the door
open with the subsequent increase in the internal temperature. The delay in activating the refrigeration unit
E
safety device gives the machine time to return to its normal operating temperature. The value of this
N
command is preset at 60 min. but can be varied from 30 to 360 min.
G
L
Command 46 Setting the trigger temperature for the refrigeration safety device:
I
This command sets the trigger temperature for the safety device, that is the temperature above which it
prevents the machine from vending the selected product (see Command 48). A warning message appears
S
on the display when the user attempts to make one of these selections. This control is disabled when the
H
machine is switched on and after the door is shut for a period of time set on command 45. The preset value
is +7°C but it can be changed to between +7°C and +35°C. When the refrigeration unit safety device trips, the
selections involved remain out of service. To reset the refrigeration unit safety device: with the door open, the
event that occurred on the master vending machine or on the slave machines connected to it, appears on the
display of the master vending machine. Press ENTER on the external keypad to reset the device. If you press
the ESC button or close the door, the action remains active and is recorded as ERROR 93. If the refrigeration
unit safety device is still active when you close the door, an acoustic alarm (series of BEEPS) will
automatically begin to sound.
Command 48 Setting trays with refrigeration safety device:
It makes it possibile to determine which of the drawers inside the +3°C. area (refer to par. TECHNICAL
FEATURES) are subject to refrigeration safety system. The control action asks, for each drawer, to be
enabled for safety = 1 or to be disabled = 0. Drawer 1 refers to the top one. By default, all drawers inside the
+3°C. area are set to 1.
10.5 TO SET MACHINE PARAMETERS
Command 50 Enter machine code:
The user is asked to enter a numeric code with max. 8 digits, which is used as the identification code when
the programming of the parameters is carried out using the key system.
Command 59 Stroke counter / error display :
If the command is set at 1, the stroke counter appears every time the door is opened.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
The products must be introduced at the correct temperature for preservation as specified by
the regulations in force. The non-observance of this regulation could activate the
"refrigeration safety device".
For detailed descriptions on the reloading modes, see paragraph "GUIDELINES FOR
LOADING PRODUCTS"
JUST NOW – Issue 00
Publicidad
Capítulos
