Submenu For Setting The Clock & Daily Event Timers (See Command 02) - FAS International JUST NOW Manual Del Usuario

JUST NOW – Issue 00
10.6 SUBMENU FOR SETTING THE CLOCK & DAILY EVENT TIMERS (SEE COMMAND 02)
Alarm set 01 Sets the year/month/day:
This command is used to set the year, month and day on the clock in the control board. The introduction
format is YYMMDD.
Alarm set 02 Sets the hour and minute:
This command is for setting the hour and minute in the realtime clock built into the electronic control board.
Key in the exact time in hours and minutes and press the ENTER pushbutton to confirm the setting.
The following procedure will set the clock at 10.30:
1. Go into programming mode to display ................................................................................. _Command 00_
2. Key in 02 and press the ENTER button to display ...................................................................... _Alarm 00_
3. Key in 2 and press the ENTER button to display the hours and minutes previously set ................. _NNNN_
4. Key in 1030 and press the ENTER button.
Alarm set 03 Setting the days of the week:
This command is used to set the day on the clock which is present on the control board; the permissible
values are from 1 (Monday) to 7 (Sunday).
Alarm 11 Lights on/off:
With this command 3 daily periods can be programmed for switching the lighting on and off. However, even
in the periods when the lighting is programmed off, simply pressing a button on the keyboard or inserting
money will activate the lighting for a period of 3' for the vend cycle to take place. If this function is not
required, program 2400 in Alarm 11.
Alarm 21 Setting discount time slots:
With this command you can program 3 daily discount time slots. In the time slots with the discount active the
machine refers to the prices set in the submenu relevant to the discounted prices. Naturally command 62 in
the main menu must be set at 1. If this function is not required, program 2400 in Alarm 21.
Alarm 31 Selections disabled for daily time periods:
This command allow the selections set at command "Alarm 36" to be disabled for 3 time periods per day. If
use of this function is not required, programme 2400 at Alarm 31.
Alarm 36 Setting the selections with timed disabling :
Upon entry to the command the system asks the operator to disable the option that concerns the entire
machine (option 1), or not (option 0). If option 0 is selected, the command allows the operator to choose
which selections must be disabled during the time slots when the "selections disabled" function is enabled
(see programming Alarms 31-34).
Example:
To activate the disabled time slot for selection 05 proceed as follows:
1. Programming mode, .......................................................................... Command 00 appears on the display
2. Type 02 and press ENTER, ................................................................... Alarms 00 appears on the display
3. Type 36 and press ENTER, , ..................................................... Select. number 00 appears on the display
4. Type 05 and press ENTER, , ............................................................ Dis./En.1/0 N appears on the display
5. Set the value 1 and press ENTER.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
29
E
N
G
L
I
S
H