Speck Normblock Multi Serie Traducción De Las Instrucciones Para El Manejo Originales página 97

Pos: 158 /Technische Dokumentation/Betriebsanleitung/Störung/Multi/Überlastung des Motors @ 4\mod_1449582210773_370.docx @ 55401 @ @ 1
Fault: Motor overload
Possible cause
Pump's back pressure is
less than that indicated in
the order.
Higher density of the
pumping liquid than that
indicated in the order.
Too high a speed.
Running on two phases.
Transport fuse not
removed from the shaft
groove.
Pos: 160 /Technische Dokumentation/Betriebsanleitung/Störung/Multi/Zu hoher Pumpendruck @ 4\mod_1449582232634_370.docx @ 55417 @ @ 1
Fault: Too high a pump pressure
Possible cause
Too high a speed.
Pos: 162 /Technische Dokumentation/Betriebsanleitung/Störung/Multi/Erhöhte Lagertemperatur @ 4\mod_1449582250316_370.docx @ 55433 @ @ 1
Fault: Increased bearing temperature
Possible cause
Pump strained or
vibrations in the pipes.
Increased axial thrust –
(further enquiry
required).
Flow rate too low.
Pos: 163 /Technische Dokumentation/Allgemeine Module/#### Seitenumbruch #### @ 0\mod_1426069111812_0.docx @ 891 @ @ 1
04/2016
Solutions
 Set operating point exactly.
 For constant overload turn the
impeller - (further enquiry
required).
 Contact manufacturer.
 Reduce speed - (further enquiry
required).
 Renew faulty fuse.
Check electrical power

connections.
 Remove the transport fuse from
the shaft groove.
Solution
 Reduce speed - (further enquiry
required).
Solution
 Check pipe connections and
pump fasteners, if necessary
reduce the pipe bracket
spacing.
 Fasten pipes using vibration
reducing materials.
Clean relief bore in impeller.

 Increase minimum flow rate.
Faults
EN 35