Harbor Breeze CC52WW5C Manual De Instrucciones página 10

FINAL INSTALLATION
2. Temporarily lift motor housing (C) to mounting bracket
(A) to determine which two motor housing mounting
screws (N) in sides of mounting bracket (A) align with
the slotted holes in the top edge of the motor housing
(C) and partially loosen these two screws (N). Remove
the other two screws (N) and motor housing lock
washers (O) from sides of mounting bracket (A). Slide
motor housing (C) over motor assembly (D), aligning
slotted holes in motor housing (C) with loosened screws
(N) in mounting bracket (A). Twist motor housing (C) to
lock. Re-insert the other two screws (N), along with lock
washers (O), to secure motor housing (C). Tighten all
screws (N) securely. (Fig. 2)
3.
Partially insert three blade screws (AA), along with
three fiber blade washers (BB), into holes on blade
arm (F) and blade (G) to attach blade arm (F) to
blade (G). Then, tighten each blade screw (AA)
starting with the one in the middle. (Fig. 3) Repeat
with remaining blades (G).
Hardware Used
Blade Screw
AA
BB Fiber Blade Washer
Locate motor screws (M) and lock washers (L) that
4.
were removed in Step 5 on page 7.
Insert two motor screws (M), along with lock washers
(L), through one blade arm (F) to attach blade arm (F)
to motor. Tighten motor screws (M) securely. (Fig. 4)
Repeat with remaining blade arms (F), making sure to
completely secure each blade arm (F) before
proceeding with the next.
2
3
x15
x15
4
C
10
A
N
O
C
AA
BB
HH
F
HH
D
M
D
N
O
G
F
L