Use; Identification Of The Hoist; Description Of The Hoist - AGM M Serie Instrucciones De Instalación Y De Manutención

1.3 USE

The "Serie M" lifts are designed and manufactured solely to raise vehicles in order to carry out inspections, maintenance and/or repairs. They
are not suitable for raising workshop machines, fork lifts and/or other kind of special machinery
• The lift should be used exclusively to raise vehicles, observing the capacity limits shown on the identification plate related to the speci-
fic lift type (Fig. 2 and 6 Fig. 15).
• The lift is not suitable to be installed and used in areas that are exposed to atmospheric agents.
• The lift is not suitable to be installed and used in areas close to vehicle washing, degreasing or cleaning operations.
• The lift must be kept clean. Should parts of the lift come in contact with extraneous substances or liquids, clean immediately taking off
completely the substances. The contact of the lift components with following substances must be avoided:
- Substances or liquids containing solvents
- Substances or liquids containing corrosive agents
- Substances or liquids containing acids (like liquids of brake circuits, liquids of batteries, detergents etc.)
- Substances or liquids containing salts.
• The lift is not suitable and must not be be used to raise people.
WARNING: The lift should only be used for the means it was designed and built for. Any other use is considered improper and therefore
rigorously forbidden:
AGM-COS.MET rejects any liability for damages to persons, animals and properties, caused by improper use of the lift or for incorrect
observance of the instructions given in this manual.

1.4 IDENTIFICATION OF THE HOIST

All lifts are equipped with identification plates (Fig. 2) containing:
A Manutacturer's marking
B Manutacturer's address
C Lift version
D Machine number
E Max. working capacity, kg
F Max. working pressure, bar
G Year of production
H EC Marking
Data (C) and (D) must always be mentioned when service and spare parts are required.
1.4 DESCRIPTION OF THE LIFT (FIG. 3)
1) Column 1
2) Column 2
3) Control column 3
4) Column 4
5) Cross beam control side
6) Cross beam control opposite side
7) Control platform P1
8) Platform 2
9) Climbing boards
10) Wheel lock
11) Auxiliar y lift guides
12) Rotating plates seat
13) Oscillating plates
14) Hydraulic unit
15) Control panel
16) SWITCH/ON
17) EMERGENCY STOP
18) Led electric supply
19) Pushbutton UP
20) Mechanical safety pawls release pushbutton
21) Pushbutton DOWN
22) Pushbutton COMPLETE LOWERING
23