Harbor Breeze PADDLE STREAM Manual Del Instalacion página 8

FINAL INSTALLATION
10. Remove the preassembled finial (L) and bowl cap
(K) from the light kit (H).
11. Place glass (J) on the preassembled pipe on light kit
(H) until it is flush with the preassembled metal disk.
Secure with previously removed bowl cap (K) and finial
(L). Tighten securely.
12. To install the fan WITHOUT the light, remove the
hex nut preassembled inside the switch housing
cover of the light kit (H) and detach the switch
housing cover.
10
H
K
L
11
12
Hex Nut
Switch
housing
cover
14
FINAL INSTALLATION
13. Place the plug (EE) into the center hole of the
switch housing cover.
14. Remove and save the three preassembled screws
from the switch housing cover. Align the holes in the
switch housing cover and the motor assembly (E),
re-installing the previously removed screws to attach
the two parts. Tighten securely.
H
13
EE
14
15
Switch
housing
cover
I
Screw