Yakima Q-TOWERS Manual Del Usuario página 4

Set M1, M3 and center bars.
TIP: To center crossbar between towers after setting your measurement use this
technique. While pushing downward and rotating the crossbar, adjust the crossbar as
needed to the left or right. Double check your m1 measurement and adjust if necessary.
Tighten tower/bar assembly.
Be sure to not
move the towers.
Label the towers.
M
1033432H-4/30
Note: Set measurements on a flat surface away from vehicle.
MUST BE PERFECTLY FLAT
MUST BE PERFECTLY FLAT
Pull the measuring tape tight to ensure accurate measurements.
Measurements must be accurate to within 1/8" (3.2 mm).
5Nm
1
M
Label front
towers.
3
Label rear
towers.
1
M
3
M
Install end caps and correct pads.
Attach correct pads. Some cars require different
pads on front (m1) and rear (m3). Pad letter is
located in the center of each pad.
keep the pads clean and
free of debris. Clean pads
as necessary, and keep
them clean by not setting
them on a dirty surface.
Snap the
covers shut.