Yakima Q-TOWERS Manual Del Usuario página 9

Install rear system: Repeat steps 12 through 16.
Overview
Perform Safety Checks With Car Doors Open.
CHECK EACH CLIP!
Pull each clip away
from car. PULL HARD!
Repeat twice.
Clip should
not move on
second pull.
Once installed, easy on easy off without tools.
REMOVING THE SYSTEM
unlock towers and open cam covers.
Lift rack up and off (do not disassemble).
1033432H-9/30
Step 12: Line rear clips with vinyl pads.
Step 13: Assemble rear Q-Clips and lock housings.
Step 14: Attach cam covers.
Step 15: Increase the tower tensions equally (gold
slider positions must match each other!).
Step 16: Perform Safety Checks With Car Doors Open.
Covers must close with firm resistance.
CHECK EACH CLIP...CHECK EACH TOWER.
FAILURE TO CHECK CLIPS AND TOWERS BEFORE DRIVING AWAY CAN
RESULT IN PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.
Prepare for Install front
installation
CHECK EACH TOWER!
grip the bar inboard to
towers; push and pull
using only arm strength.
Install rear
towers
towers
If any of the clips or Towers move, reset m4, check gold
slider positions, and fine tune by tightening adjustment
posts gradually (step 15b). If there is still movement after
fine tuning, verify the m3.
INSTALLING RACKS AGAIN
• Open cam covers.
• Clean roof and place towers at M2 and M4
positions; measure carefully.
• Make sure clips are seated properly, then close
cam covers with firm resistance.
PERfORm SAfETY CHECkS ON ALL TOWERS AND
CLIPS AfTER EVERY INSTALLATION! (Step 21)
Perform saftey
checks
YOU ARE
HERE