4.2.8
4.2.9
4.2.10
AE1015/AE1015-3/AE1015H/AE1015H-3
中文
EN
Fig. (4-5) Unscrew the fastening nut (1) at the front end of large
cylinder piston rod, take off the bolt and nuts (3) and (4) fixing the
arm and hang the tension spring (Fig. 4-5-2)
Fig. 4-5
Fig (4-6) Load the tire-pressing arm (1) into the tire-pressing arm
support plate on the cabinet to align the holes, insert the bolt (Fig.
4-5-3), tighten the nut (Fig. 4-5-4) and hang the tension spring (Fig.
4-6-3).
Fig. 4-6
Insert the piston rod from the hole in the sliding sleeve of arm (Fig.
4-7-1). With the surface of sliding sleeve (Fig. 4-7) outwards, fit the
unscrewed nuts into the front of piston rod. The screwing length of
nut depends on the inner limit position of the piston rod.
Fig. 4-7
DE
RU
KO
PT
JA
ES
45