Harbor Breeze KEYPORT Manual Del Usuario página 10

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
3. Slide the downrod (A) into the yoke of the motor
assembly (G), align the holes, and re-install the
downrod clip (LL) and pin (MM). Then re-tighten the
motor housing set screws (NN) and slide the yoke
cover (B) down until it rests on top of the motor
assembly (G).
Hardware Used
LL
Downrod Clip
MM
Downrod Pin
Motor Housing
NN
Set Screw
4. Depending on the length of downrod (A) you use,
you may need to cut the lead wires back to simplify
the wiring. If you decide to cut back the lead wires,
it is suggested that you do so in the following
manner: Take the lead wires and make sure that you
have pulled them all the way through the top of the
downrod (A) and measure 8 in. of lead wire, and then
cut the excess wire off with wire cutters.
3
LL
x 1
x 1
x 2
4
10
B
A
MM
NN
Lowes.com/harborbreeze
G
A