Setting Up; Operation; Using Auto Mode - UNITED OFFICE UAV 190 B2 Instrucciones De Uso

Setting up

NOTE
► As every shredder is tested for functionality after manufacture, it is possible
that you may find paper residue in the cutting blades.
● Remove all packaging materials from the appliance.
● Place the shredder on a suitable container:
place the broad end of the appliance on the edge of the container. Then pull
out the telescopic arm 6 until it sits securely on the other edge.
● Insert the plug into a mains power socket.

Operation

CAUTION! MATERIAL DAMAGE!

Using auto mode

Set the switch 1 to the "AUTO" for shredding. The power LED 4 lights up
●
green. The motor starts automatically as soon you insert paper and switches
off automatically once no further paper is inserted.
NOTE
Always insert smaller pieces of paper into the middle of the cutter opening 2.
►
This is where the contact that starts the cutting process is located.
NOTE
If the appliance overheats, the overheat LED 5 lights up as soon as the paper
►
touches the contact which starts the cutting process. The appliance will not
start cutting. Proceed as described in the section "Note regarding overheating
of the appliance".
UAV 190 B2
You can shred up to 6 sheets (80 g /m
Remove all paper clips or staples before inserting the paper into
the cutter opening 2. The cutting blades might otherwise be
damaged.
2 paper) at the same time.
GB │ IE
│
5 ■