Tabla de contenido
Publicidad
Multifunction and wheel circumference adjustment
The configuration operations include the 12/24 hour clock, the gear change according to rpm indicator, the number of engine revolutions by
signal, the wheel circumference and the units of measurement The configuration must be carried out step by step. The computer will return
automatically to the main screen if no button is pressed in any adjustment screen for 75 seconds.
1.
Press the MODE and RESET buttons to switch to the adjustment screen. In the adjustment screen, press the RESET button to increase the
value of the flashing digits or to convert units, press the MODE button to confirm the configuration and move on to the next digit or the next
adjustment screen to be configured. Press the MODE button for 2 seconds in any adjustment screen to conclude the configuration and return
to the main screen.
2.
The screen shows 12 or 24 h, and the symbols: XX: XX-XX, and AM/PM if the 12h option has been selected.
3.
When the RESET button is pressed the 12/24h system changes, and when MODE is pressed, the configuration concludes and the configuration
of the clock digits opens.
4.
Press the RESET button to increase the value of the flashing digit one by one; press the MODE button to confirm the configuration and pass
on to the following digit.
5.
Press the MODE button to switch to the adjustment screen of the gear change according to rpm, once the clock has been configured.
6.
The screen will show RPM rXXX00. Press the RESET button to increase the value of the digit one by one; press the MODE button to confirm
the configuration and pass on to the following digit.
7.
Press the MODE button to switch to the adjustment screen for the engine revolution by signal, once the gear change according to rpm
configuration is completed.
8.
The screen will show SPC-X.X RPM, with 1.0 as the default value There are 4 options 1.0, 2.0, 3.0 and 0.5. They correspond to the number
of revolutions for each signal.
9.
Press the RESET button to move between the four values . Press the MODE button to confirm the configuration and to move on to the wheel
circumference adjustment screen
10.
When cXXXX appears on screen, the "c" stands for "circumference" and is followed by four digits by default; the flashing digit is the one to be changed.
For example, a value of 2.0 means that the motor turns over twice to produce a signal.
- 46 -
Publicidad
Tabla de contenido
