Work Position - Nogueira EXPRESS-5040 Manual De Instrucciones

WORK POSITION

The Baler leaves the factory with the head in the transport position. Before
starting the baling it is necessary to place it the work position, following the
instructions below.
1
fig. 10
Position 1: For transport.
Position 2: Indicated for places where it is necessary to maneuver the
machine constantly (small areas). In this position it is important to see
that the tractor wheels do not go over the ridges.
Position 3: It is the most advisable, mainly for baling in large areas.
PLACING IT IN THE WORK POSITION:
1- Stretch the cord A up to the tractor seat.
2- Place a wedge in front of the right wheel of the baler (fig.14).
3- Start the tractor and manually pull the cord to release the lock.
4- Move the tractor forwards, until the head moves to the side and locks in the
work position.
CABLE
A
fig. 13
20
2
fig. 11
NOTE: Upon taking the cable on the tractor
leave sufficient slack for maneuvering.
Instructions Manual
3
fig. 12
fig. 14
WEDGE THE WHEEL