Nogueira EXPRESS-5040 Manual De Instrucciones página 66

The arm knife holder has on its bottoom a small slot (shown in fig.141), which
should pass close to the knotmaker foot to remove the loop. If there is a gap
in this place, the loop will not be removed from the stand and the cord will be
crushed or damaged.
Observe the fig.141, the slot must touch the knotmaker foot back when it get
the 15 millimeters from the tip of this (fig.141).
fig.140
IMPORTANT:
After adjusting the blade holder arm, verify if the support of the knotmaker turns
freely (without touching the arm). Also see if the slot R of the arm goes close
to the sides of the support, as indicated on the previous page.
A thick surface of deformations in the blade holder arm can cause problems in
the tying and damage to the cords. This can occur when the arm is worn. In this
case, the blade holder arm must be replaced.
BLADE HOLD ARM
66
15 mm
fig.142
Instructions Manual
SLOT
fig.141
Maintain this area of the
blade holder arm smooth
and free of burrs.
fig.143