Harbor Breeze LYNNHAVEN DTA54GPT5CL Manual Del Usuario página 11

FINAL INSTALLATION
3. Install the six candelabra base 25 watt (max.)
bulbs (I) supplied with this fan into the top of the
motor housing (D). (Fig. 3)
Important: When replacing bulbs, please allow
bulb(s) and glass housing (L) to cool down before
touching them.
4. Remove one screw from outer ring on underside of
motor housing (D) and partially loosen the other two
screws. Set glass housing (L) gently into the groove at
the bottom of the glass housing cage (M). Raise glass
housing (L) and glass housing cage (M) toward motor
housing (D) until glass housing (L) and glass housing
cage (M) touch bottom of motor housing (D). Align
slotted holes in glass housing cage (M) with loosened
screws on bottom of motor housing (D). Twist glass
housing cage (M) to lock. Re-insert screw that was
previously removed. Secure glass housing (L) and glass
housing cage (M) by tightening all three screws. (Fig. 4)
Be sure to tighten screws completely but be careful not
to overtighten screws as glass may crack or break.
Partially insert three blade screws (AA), along
5.
with three fiber blade washers (BB), to attach one
blade arm (G) to a blade (F). Then, tighten each
blade screw (AA) starting with the one in the
middle. (Fig. 5) Repeat with remaining blades (F).
Hardware Used
Blade Screw
AA
BB Fiber Blade Washer
Locate motor screws (Q) and lock washers (R)
6.
that were removed in Step 5 on page 7.
Insert two motor screws (Q), along with lock
washers (R), through one blade arm (G) to attach
blade arm (G) to motor. Tighten motor screws
(Q) securely. (Fig. 6) Repeat with remaining
blade arms (G), making sure to completely
secure each blade arm (G) before proceeding
with the next.
3
I
4
5
x15
x15
6
11
D
L
M
AA
BB
G
R
G
Q
D
F
L
M