Wiring - Harbor Breeze LYNNHAVEN DTA54GPT5CL Manual Del Usuario

FAN MOUNTING
4.
If you decided to cut back the lead wires in Step 3,
strip 1/2 of an inch of insulation from end of white
wire. Twist stripped ends of each strand of wire
within the insulation with pliers. (Fig. 4) Repeat
Step 4 for black, blue (if applicable) and green
wires.
5.
Install ball end of downrod (A) into mounting
bracket (C) opening. Align slot in ball with tab in
mounting bracket (C). (Fig. 5)
DANGER: Failure to align slot in ball with tab
may result in serious injury or death.

WIRING

WARNING: To reduce the risk of fire, electrical shock, or
personal injury, wire connectors provided with this fan are
designed to accept only one 12 gauge house wire and two
lead wires from the fan. If your house wire is larger than 12
gauge or there is more than one house wire to connect to the
two fan lead wires, consult an electrician for the proper size
wire connectors to use.
CAUTION: Be sure outlet box is properly grounded and that a
ground (green or bare) wire is present.
WARNING: If house wires are different colors than
referred to in the following steps, stop immediately. A
professional electrician is recommended to determine wiring.
1. Choose wiring diagram (Fig. 1A, Fig. 1B or Fig. 1C) that
fits your situation and make appropriate wiring
connections as follows: [NOTE: For each wire connection
below, use one of the wire connectors (CC) provided,
making sure to screw wire connector (CC) on in a
clockwise direction.]
1A. FAN AND LIGHT CONTROLLED BY PULL
CHAINS: Connect BLACK and BLUE wire from fan to
BLACK wire from ceiling. Connect WHITE wire from fan
to WHITE wire from ceiling. Connect all GROUND
(GREEN) wires together from fan (on downrod and
mounting bracket) to BARE/GREEN wire from ceiling.
(Fig. 1A)
4
5
Ball
B B
FAN AND LIGHT CONTROLLED BY PULL CHAINS
1A
120 V Power
FROM
CEILING
FAN
GREEN
8
C
Tab
Hanging
Ball Slot
A
BLACK
WHITE
GROUND/GREEN (BARE)
WHITE
GREEN
BLACK
BLUE
WHITE
FROM FAN