Temperature Measurement - Covidien Genius 2 Manual De Instrucciones

Temperature Measurement

Training on the use of the Genius™ 2 Tympanic Thermometer and Base is important for user competence. Please follow these basic
steps below and for further information please visit www.Genius2Training.com
1. Visually inspect the patient's ear canal. Remove the Genius™ 2 Tympanic Thermometer and Base from
the base.
2. Inspect the probe lens. If any debris is present, clean the probe tip per the directions in Section VII,
3. Press the scan button to verify functionality and mode selection on the LCD screen. Install a probe cover
4. Inspect the probe cover to make sure it is fully seated (no space between cover and tip base) and no
5. Place the probe in the ear canal and seal the opening with the probe tip. For consistent results, ensure
6. Once positioned lightly in the ear canal press and release the scan button. Wait for the triple beep
7. Remove the probe from the ear as soon as the triple beep is heard.
Tympanic Thermometer and Base
Cleaning. If the probe tip is clean, proceed to step 3.
by firmly inserting the probe tip into a probe cover. After the probe cover is installed, the thermometer
will perform a system reset. The thermometer will then display dashes, the equivalence mode, and the
thermometer icon.
holes, tears, or wrinkles are present in the plastic film.
that the probe shaft is aligned with the ear canal.
before removing the thermometer.
5
en
Table of Contents