INSTALLING THE BATTERIES
Remove the face plate of the Wall Switch by lifting at the top
and then insert the supplied 12V battery. Duracell MN21/
Eveready A23/GP 23A all 12V (Fig. 20).
Replace the switch face plate.
To prevent possible damage to the transmitter, remove these
batteries if not used for long periods of time (months).
OPERATING INSTRUCTIONS
HI Button
=
High Speed
MED Button
=
Medium Speed
LOW Button
=
Low Speed
FAN OFF Button = Motor Off
Light Button
= the "LIGHT" button turns the light ON or OFF
and also controls the brightness setting. (Fig. 21)
Press and hold either button to set the desired brightness level. The next time you
turn the light on, the system will remember this setting.
Press and release either button to turn the light ON or OFF.
This control system is NOT designed to "Reverse" the rotation of the blades. To set
the fan blades in reverse, the reverse slide switch is located on the top of the motor
housing (Fig. 22).
Do not operate reversing switch while fan blades are in motion. Fan must be turned
off and blades stopped before reversing blade direction.
16 | KICHLER.COM
U/L
HI
LIGHT
MED
D/L
LOW
ON ECE
FAN OFF
1 2 3 4
Fig. 20
Fig. 21
Slide switch
Fig. 22