Transport And Storage - RK Rose+Krieger MonoLine R Instrucciones De Montaje

4

Transport and storage

Transport inspection
Transport
Storage
26.03.2019
NOTICE!
It is prohibited to commission damaged linear
units!
Immediately check the delivery upon receipt to ensure that it is
complete and free from transport damage. Report the extent of the
damage to the person responsible and to RK Rose+Krieger GmbH
immediately.
WARNING!
Risk of injury due to improper transport!
Loads can swing out, topple over and fall down during
lifting operations. This can cause severe injuries.
–
–
–
–
Observe the following during transport:
n Ensure that, when a crane, lifting cart or even persons are
lifting the linear unit, it is not picked up by its end elements.
n Move the linear unit's guide carriage into its end position and
secure it before transport.
n Avoid impact on the linear unit's shaft ends during transport.
Store the linear units under the following conditions:
n Only place it on a load-bearing substrate.
Ensure that the entire guide profile or a corresponding number
of support points along the guide profile are placed flush on the
substrate.
n Avoid contact with solvent-based varnishes.
n Do not expose to air containing oil.
Storage temperature: 0 - 60°C
n
Humidity: Temperatures below the dew point are not permitted.
n
Deviating environmental conditions must be approved
by RK Rose+Krieger GmbH.
Linear unit RK MonoLine R/RK MonoLine Z
Transport and storage
Never step under or into the pivoting range of sus-
pended loads.
Only use approved lifting gear and load suspen-
sion devices with a sufficient load-bearing capacity.
Observe the linear unit's centre of gravity.
Wear an industrial protection helmet.
91