Assembling The Synchronisation Shaft; Assembling The Synchronisation Shaft (Without Protective Tube) - RK Rose+Krieger MonoLine R Instrucciones De Montaje

5.4.2 Assembling the synchronisation shaft

5.4.2.1

Assembling the synchronisation shaft (without protective tube)

Applicable to
Assembling screw-in hubs
Fig. 22: Assembling screw-in hubs
Assembling the synchronisation
shaft
Fig. 23: Assembling the synchronisa-
tion shaft
26.03.2019
Assembling optional modules > Assembling the synchronisation shaft
Version
Size
Personal:
Schutzausrüstung:
Prerequisites:
n The electric gear unit and/or motor (if available) are secured
against restarting.
n Linear units to be connected must be fixed in the substrate.
1. Place the screw-in hubs (Fig. 22/2) on the timing belt shafts
(Fig. 22/1) of both linear units.
2. Tighten 4 screws each (Fig. 22/3), alternating diagonally:
Size
40
60, 80, 120 M8
3. Insert gear rings (Fig. 22/4) into the screw-in hubs.
4. Place the clamping hubs (Fig. 23/2) on both sides of the steel
tube (Fig. 23/3).
5. Place the steel tube (Fig. 23/3) with the loose clamping hubs
between the screw-in hubs of both linear units.
6. Slide clamping hubs (Fig. 23/2) into the screw-in hubs
(Fig. 23/1).
7. Tighten the screw (Fig. 23/4) on each clamping hub.
Linear unit RK MonoLine R/RK MonoLine Z
RK MonoLine Z
40/60/80/120
n Assembly staff
n Protective clothing
n Protective gloves
n Safety shoes
Screw size
M4
Do not fix the clamping hubs to the steel tube
yet.
Ensure that the clamping hubs on the steel tube
engage correctly in the screw-in hubs on the
linear units.
Assembly
Tightening torque [Nm]
4.2
40
99