Saving And Loading An Individual Job From A Usb Drive; Power Source Status Menu; Accessories Menu - Cebora KINGSTAR 400 TS Manual De Instrucciones

7�1�8

Saving and loading an individual JOB from a USB drive

To save an individual JOB onto a USB drive:
Loading an individual JOB from a USB drive:
7�2

Power source status menu

The power source status menu displays information about the welding time, number of ignitions, power source output
voltage and current, power source internal temperatures, voltage and current of the motor, the amount of wire fed.
To access the power source status menu, select Menu ->
7�3

Accessories menu

Activate the various accessories available in the power source from the following menu.
If accessories are present in the welding system, they must be connected to the power source before powering
up. Connecting/disconnecting accessories while the power source is switched on leads to system malfunctions
and under extreme circumstances could compromise the integrity of the welding system. CEBORA SpA does not
provide warranty coverage for inappropriate use of the welding system.
To access the Accessories menu, select Menu->Accessories
86/109
Insert a backup drive into a USB port.
Select the JOB to be saved by knob I�
Press the pushbutton
The JOB is saved in file_name.zip.
Insert a backup drive into a USB port.
Turn knob I and select the memory location to load the JOB
Press the pushbutton
Select the previously saved job file_name.zip from the USB drive and confirm
by pressing knob I.
The JOB is loaded in the chosen position.
NOTICE
Accessories main screen
.
.
3301065/A