Installing The Fan Blades - Luminance Brands Kathy Ireland Home CF835AP00 El Manual Del Propietario

11.1
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flanges when installing the flanges, balancing
the blades, or cleaning the fan. Do not insert foreign
objects between rotating fan blades.
Choose the Blade Decorative Color you prefer and
prepare to mount the Blade Flange, as follows:
Mount the Fan Blade to the Blade Flange using the
Three #10-24 x 7 mm Washer Head Screws (supplied) .
Securely tighten each Screw (Figure 22) .
Repeat this procedure for the other Four Blades and
Blade Flanges . Make sure all Screws are tightened .
11.2
Remove the Three Rubber Shipping Spacers and
Screws to free the Motor Hub for installation of the
Ceiling Fan Blade Assemblies, as follows:
Push in, on the Rubber Shipping Spacer to relieve the
pressure from the Motor Housing (Figure 23) .
Rotate the Motor Hub to align the Switch Housing Hole
over the Shipping Spacer Screw (Figure 23) .
Remove and Discard the Three Shipping Spacer
Screws and Rubber Shipping Spacers (Figure 23) .
11.3
NOTE: Take care not to scratch the Fan Motor/
Housing Assembly when installing the Ceiling Fan
Blade Assemblies.
Rotate the Motor Hub to align the Switch Housing
Hole with the Motor Hub Threaded Hole for
installation of the Ceiling Fan Blade Assemblies, as
follows:
Attach Securely the Ceiling Fan Blade Assembly to the
Motor Hub by tightening the Two Preassembled Blade
Flange Screws to the Motor Hub (Figure 24) .
Each Blade Flange has an Interlocking Edge . Rotate
Motor Hub Clockwise and Attach each Ceiling Fan Blade
Assembly to Interlock each Blade Flange (Figure 24) .
A spare 1/4-20 x 14 mm Pan Head Screw with
Lockwasher is in the hardware bag, if needed .

11. Installing the Fan Blades

Figure 22
MOTOR HUB
Figure 23
MOTOR
INTERLOCKING
HUB
FLANGE EDGE
Figure 24
16
#10 - 24 x 7 mm WASHER HEAD
SCREWS (3 per blade)
FAN BLADE
BLADE FLANGE
PUSH
IN
RUBBER
SPACERS (3)
SWITCH
HOUSING HOLE
RUBBER SPACER
SCREWS (3)
CEILING FAN
BLADE
ASSEMBLY
SWITCH
HOUSING
HOLE
1/4-20 x 14 mm PAN
HEAD SCREW WITH
LOCKWASHER (2 per
flange - preassembled)
ETL Model No.: CF835