Steren COM-822 Manual Del Usuario página 13

Channel - This field determines which operating frequency will be
used. The default channel is set to 6. It is not necessary to change
the wireless channel unless you notice interference problems with
another nearby access point.
Channel width - Select any channel width from the pull-down list.
The default setting is automatic, which can adjust the channel width
for your clients automatically.
These settings are only for basic wireless parameters. For advanced
settings, please refer to wireless section.
If you Choose "Static IP", the Static IP settings page will appear,
shown in figure
Antes de utilizar su nuevo Kit C
The IP parameters should have been provided by your ISP.
IP Address - This is the WAN IP address as seen by external users
on the Internet (including your ISP). Enter the IP address into the
field.
Subnet Mask - The Subnet Mask is used for the WAN IP address, it
is usually 255.255.255.0
Default Gateway - Enter the gateway IP address into the box if
required.
Primary DNS - Enter the DNS Server IP address into the box if
required.
Secondary DNS - If your ISP provides another DNS server, enter it
into this field.
ENGLISH-13