Quick Setup - Steren COM-822 Manual Del Usuario

2. WIRELESS
This field displays basic information or status for wireless function,
including Wireless Radio, SSID, Channel, Mode, Wireless MAC
address and IP address.
3. WAN
These parameters apply to the WAN port of the router, including
MAC address, IP address, Subnet Mask, Default Gateway, DNS
server and WAN connection type. If PPPoE is chosen as the
WAN connection type, the Disconnect button will be shown here
while you are accessing the Internet. You can also cut the
connection by clicking the button. If you have not connected to
the Internet, just click Connect to establish the connection.
4. TRAFFIC STATISTICS
This field displays the router's traffic statistics.
5. SYSTEM UP TIME
The time of the router running from it's powered on or reset.

QUICK SETUP

Please refer to Section: "Quick Installation Guide."
QSS
QSS function will help you add a new device to the network quickly.
If the new device supports Wi-Fi Protected Setup and is equipped
with a configuration button, you can add it to the network by pressing
the configuration button on the device and then press the button on
the router within two minutes. The status LED on the router will light
green all the time if the device has been successfully added to the
network. If the new device supports Wi-Fi Protected Setup and the
connection way using PIN, you can add it to the network by entering
the router's PIN.
ENGLISH-16