Connecting The Router - Steren COM-822 Manual Del Usuario

CONNECTING THE ROUTER

Before you install the router, you should connect your PC to the
Internet through your broadband service successfully. If there is
any problem, please contact your ISP. After that, please install
the router according to the following steps. Don't forget to pull
out the power plug and keep your hands dry.
1. Power off your PC(s), Cable/DSL modem, and the router.
2. Locate an optimum location for the router. The best place
is usually near the center of the area in which your PC(s) will
wirelessly connect. The place must accord with the Installation
Environment Requirements.
3. Adjust the direction of the antenna. Normally, upright is a good
direction.
4. Connect the PC(s) and each Switch/Hub on your LAN to the
LAN Ports on the router, shown in fi gure 1.
5. Connect the DSL/Cable Modem to the WAN port on the router,
shown in fi gure 1.
6. Connect the AC power adapter to the AC power socket on the
router, and the other end into an electrical outlet. The router will
start to work automatically.
7. Power on your PC(s) and Cable/DSL modem.
ENGLISH-05