Configuring Videohub Smart Control Pro - Blackmagic Design Videohub Master Control Pro Manual De Instalación Y Funcionamiento

Click on the desired button to edit its label.

Configuring Videohub Smart Control Pro

Videohub Hardware Panel Setup lets you customize the hardware features of each Videohub
control panel.
Number of Destinations
Videohub Smart Control can be configured as a Cut-Bus controller or as an XY controller. When
configured as a Cut-Bus controller, every button represents an SDI source and there is only one
destination.
When configured as an XY controller, Videohub Smart Control Pro can work with up to
24 destinations. The source buttons will illuminate white and the destination buttons will
illuminate gold. Use this configuration if you don't intend to dedicate a Videohub Smart Control
Pro unit to each destination device.
Videohub Smart Control Pro configured with multiple destinations.
Cut-Bus Configuration
1 Drag the Number of Destinations slider to 1.
2 Click on the Destination button. In the Router SDI Out A field, enter the number
of the Videohub output port to which the destination device is connected. If your
destination device is receiving dual or quad link SDI, you will also need to enter an
output port number into the Router SDI Out B, C and D fields where required. There
is a Router Remote field if your Videohub is also routing RS-422 deck control to the
destination device.
3 Click OK to confirm. All the buttons will become white, indicating that they are
all sources.
4 Click on each white button in the software interface to configure the source buttons.
5 In the Router SDI In A field, enter the number of the Videohub input port to which the
source device is connected. If your destination device is receiving dual or quad link
SDI, you will also need to enter an input port number into the Router SDI In B, C and D
fields where required. There is a Router Remote field if your Videohub is also routing
RS-422 deck control from the source device.
6 Click OK to confirm.
Getting Started 15