Blackmagic Design Videohub Master Control Pro Manual De Instalación Y Funcionamiento página 16

Enter the number of the Videohub port to
which the SDI device is connected.
XY Controller Configuration
1 Drag the Number of Destinations slider to the desired number.
2 You can now configure the destination buttons by clicking on each gold button in the
software interface. In the Router SDI Out A field, enter the number of the Videohub
output port to which the destination device is connected. If your destination device
is receiving dual or quad link SDI, you will also need to enter an output port number
into the Router SDI Out B, C and D fields. There is also a Router Remote field if your
Videohub is also routing RS-422 deck control to the destination device.
3 Click OK to confirm. If you increase the number of destination buttons, there will be a
matching decrease in the number of available source buttons.
4 Click on each white button in the software interface to configure the source buttons.
5 In the Router SDI In A field, enter the number of the Videohub input port to which the
source device is connected. If your destination device is receiving dual or quad link
SDI, you will also need to enter an input port number into the Router SDI In B, C and
D fields where required. There is also a Router Remote field if your Videohub is also
routing RS-422 deck control from the source device.
6 Click OK to confirm.
Click on the desired Destination
button to configure it.
Getting Started 16