Using Videohub Smart Control Pro As A Cut-Bus Controller; Using Videohub Smart Control Pro As An Xy Controller - Blackmagic Design Videohub Master Control Pro Manual De Instalación Y Funcionamiento

To unlock a destination using Videohub Master Control:
1 Press the DEST button. The destination field will highlight blue on the LCD.
2 If the desired route is not already displayed on the LCD, use the pushbuttons and/or
scroll wheel to find the destination to be unlocked. The destination field will show a
lock icon for the locked destination.
3 Press and hold the gold DEST button until the lock icon disappears from the destination
field of the LCD.
4 Press DEST again to return Videohub Master Control to its idle state and the destination
field will revert to gray.
The lock icon disappears from the destination
field when the destination is unlocked.
Using Videohub Smart Control Pro as a Cut-Bus Controller
If Videohub Smart Control Pro has been configured as a Cut-Bus controller, the destination
device has already been chosen and you only need to choose a video source.
1 Select a white video source button. The button will light up to distinguish it from the
other sources. The video source will immediately connect and be viewable on the
destination device.
2 If the Take button has been enabled, the new source button and the Take button
will flash. The route change will only take place when you confirm by pressing the
Take button.
Videohub Smart Control Pro configured as a Cut-Bus controller and with a Take button.
Using Videohub Smart Control Pro as an XY Controller
If Videohub Smart Control Pro has been configured as an XY controller, destination buttons
light up gold and source buttons light up white. When working with multiple destinations, always
select a destination button before selecting a source button.
To change routes:
1 Select a gold destination button and it will light up brightly to distinguish itself from
the other destination buttons. If a video source has previously been connected to this
destination, its button will light up white.
2 To connect a new source to the destination, press the desired video source button.
The video source will immediately be connected and viewable on the destination
device. The new source button will be brightly lit and the previous source button will
dim to normal. To change another route, select another destination button and then
select a new source button.
Getting Started 27