Getting Help - Blackmagic Design Videohub Master Control Pro Manual De Instalación Y Funcionamiento

Adding a GPI and Tally Interface Over a Network
You may want to configure a second GPI and Tally Interface but it may be in another location
and only accessible over a network. You can add it to your list manually by entering its IP
address into Videohub Hardware Panel Setup.
If you do not know the IP address of the GPI and Tally Interface you want to add, connect it to a
computer with USB, open Videohub Hardware Panel Setup and note down the IP address in the
Network Settings tab.
If you do not have access to the unit because it is in another location, you can find it on the
network using the Bonjour browser. This application will show you all the devices on your
network and will give you the IP address of the GPI and Tally Interface you wish to add.
1 Press the + (add device) button at the bottom of the Videohub Control Panels pane.
2 Type in the IP address of the GPI and Tally Interface and press OK.
3 The second GPI and Tally Interface will appear in the list with any other devices that are
connected to the Videohub.
Press the + (add device) button and enter the IP address of a GPI and Tally Device you want
to add. Press the Identify button to activate the LED on a selected GPI and Tally Interface.

Getting Help

The fastest way to obtain help is to go to the Blackmagic Design online support pages and
check the latest support material available for your Blackmagic Design Videohub Control.
Blackmagic Design online support pages
The latest manual, software and support notes can be found at the Blackmagic Design support
center at www.blackmagicdesign.com/support.
Contacting Blackmagic Design support
If you can't find the help you need in our support material, please use the "Send us an email"
button to email a support request. Alternatively, click on the "Find your local support team"
button and call your nearest Blackmagic Design support office.
Checking the version currently installed
To check which version of Videohub Control is installed on your computer, open the Blackmagic
Videohub Control application. From the Blackmagic Videohub Control menu, select About
Blackmagic Videohub and note the version number.
How to get the latest updates
After checking the version of your Blackmagic Videohub Control on your computer, please visit
the Blackmagic Design support center at
latest updates. While it is usually a good idea to run the latest updates, it is a wise practice to
avoid updating any software if you are in the middle of an important project.
www.blackmagicdesign.com/support to check for the
Getting Started 31