Blackmagic Design Videohub Master Control Pro Manual De Instalación Y Funcionamiento página 26

7 Type in the source equipment number using the numeric pushbuttons, e.g., 03 for the
capture card Edit 03. Each numeric button will flash white as you press it.
8 The TAKE button will flash red, awaiting your confirmation of the route change. Press
TAKE and the route will change immediately. Otherwise, press CLEAR and no route
change will take place. Videohub Master Control will then return to its idle state with the
latest route displayed on the LCD.
If any button you have customized for either a source or destination flashes but does
not stay lit, Videohub Master Control is preventing you from selecting the button
because the equipment type has not been labeled as a source or destination device or
does not match the current routing level. For example, cameras should not usually be
set as destination devices, monitors should not be set as source devices and won't
match the RS-422 routing level. Refer back to Creating Button Labels in Configuring
Videohub Master Control Pro for steps on how to change this.
If you know that you want Edit 3 as the source, and VTR 1 as the destination,
you can select the route directly without any scrolling being necessary.
In this example, press DEST, press the customized VTR button and then
press 1. VTR 1 will be shown in the destination field. Now press SRC,
press the customized Edit button and then press 3. "Edit 3" will be shown
in the source field. Finally, press TAKE to confirm the route change.
Locking and Unlocking Routes
To lock a destination using Videohub Master Control:
1 Set the destination and source using whichever method you prefer. Once the route has
been set, Videohub Master Control will return to its idle state.
2 Press the DEST button. The destination field will highlight blue on the LCD.
3 If the desired route is not already displayed on the LCD, use the pushbuttons and/or
scroll wheel to find the destination to be locked.
4 Press and hold the gold DEST button until a lock icon appears in the destination field
of the LCD.
5 Press DEST again to return Videohub Master Control to its idle state and the destination
field will revert to gray.
The destination field shows a lock icon if the destination is locked.
Getting Started 26