Setup - AMATECH F-ABSL Manual Del Usuario

INSTRUCTIONS FOR USE

3.2 Setup:

a. Hold the Armboard in a horizontal
position.
b. Tilt the end
approximately 2 to 3" (5 to 7,6 cm). Hook
the upper jaw of the mount over the
table rail and allow the end of the
board to return to horizontal position.
The latch should engage the bottom
edge of the rail and the Armboard
should now be fastened to the table. Lift
the end of the board to ensure that it is
locked to the rail.
To adjust the
c.
angulation SIMPLY LIFT UP ON THE END
OF THE BOARD and move it in the
desired direction. Lower the end of the
Armboard and the weight of the arm
will lock the board in position. Do not
apply excessive force when lifting the
end of the Armboard. Only 2-3lbs (0,9-
1,4kg) of such force should be required
to disengage the lock mechanism
during repositioning. Extreme upward
forces could damage the Armboard.
Be careful not to install the armboard at a tablesection articulation level. the
armboard could be damaged in case of movement.
Document Number: 80028226
Version: B
of the board
Armboards radial
Page 12
up
Ref Blank Template: 80025118 Ver. E
Issue Date: 17 MAR 2020