Bondioli & Pavesi Global Traducción De Las Instrucciones Originales página 21

Remove the base cone and the shield tube.
47
48
Remove the outer cone and the bearing ring.
G9 SHIELD ASSEMBLY
49
Grease the bearing groove on inner yokes.
Fit the bearing ring into the yoke groove with the grease fitting facing the
50
drive tube.
51
Install the outer cone, inserting the grease fitting through the proper hole.
Install the base cone and shield tube.
52
Tighten the Philips head screws.
53
Use of electric powered screwdrivers is not recommended.
CV JOINT SHIELD DISASSEMBLY
Remove the screws arranged radially around the circumference of the CV
54
cone.
55
Remove the screws from the base cone.
56 Remove the base cone and the shield tube.
Remove the CV cone.
57
Disengage the retaining spring, leaving it inserted in one of the two holes of
58
the bearing ring to avoid losing it.
Spread the bearing rings and remove from their groove.
59
CV JOINT SHIELD ASSEMBLY
Grease the seats and install the shield support bearings.
60
Fit the bearing ring onto the inner yoke with the reference pin facing the
drive tube.
61
Install the bearing ring on the CV body with the reference pins facing the
inner yoke. The bearing ring is equipped with a grease fitting, used only for
50° CV joints. This grease fitting is not used with 80° CV joints.
ENG
21