Initial Configuration Wizard - Juniper Networks SSG 20 Guía De Instalación Y Configuración De Hardware

Appendix B

Initial Configuration Wizard

This appendix provides detailed information about the Initial Configuration Wizard
(ICW) for an SSG 20 device.
After you have physically connected your device to the network, you can use the
ICW to configure the interfaces that are installed on your device.
This section describes the following ICW windows:
Rapid Deployment Window on page 64
Administrator Login Window on page 64
WLAN Access Point Window on page 65
Physical Interface Window on page 65
ADSL2/2+ Interface Window on page 66
T1 Interface Windows on page 68
E1 Interface Windows on page 73
ISDN Interface Windows on page 75
V.92 Modem Interface Window on page 78
Eth0/0 Interface (Untrust Zone) Window on page 78
Eth0/1 Interface (DMZ Zone) Window on page 79
Bgroup0 Interface (Trust Zone) Window on page 80
Wireless0/0 Interface (Trust Zone) Window on page 81
Interface Summary Window on page 82
Physical Ethernet DHCP Interface Window on page 83
Wireless DHCP Interface Window on page 83
Confirmation Window on page 84
63