Publicidad
Installation and Operation Manual
X-VAP-VDM100-eng
Part Number: 541B178AAG
December, 2012
2.5 Transit Precautions
2.6 Removal from Storage
2.7 Product Safety Information
2.7.1 Hazards
2.7.2 Safety Interlocks
2.7.3 VDM100 Outlet Fitting
Brooks
To safeguard against damage during transit, transport the instrument to the
installation site in the same container used for transportation from the
factory if circumstances permit.
Upon removal from storage, a visual inspection should be conducted to
verify the condition of the equipment is "as received." If the equipment has
been in storage in conditions in excess of those recommended
(See Section 2-3), the device should be subjected to a pneumatic pressure
test in accordance with applicable vessel codes.
Make sure you understand the following safety information before you
install and operate the VDM100.
The VDM100 does not use hazardous chemicals or gases in the normal
operation or maintenance of the unit. Nitrogen is used during the drain
cycle and de-ionized water is used as the source for creating water vapor.
The VDM100 uses 115/230 Vac to power the tank heaters. The tank heaters
have a primary protection of two fuses located in the fuse drawer of the
power entry module. The fuses are rated for 3 amps at up to 250 Vac. A
secondary form of protection for the tank heaters is a Thermal Cut-Off fuse
(TCO) in series with the heaters.
The outlet fitting will become hot during normal operation. Take the
necessary precautions to avoid being burned such as wearing gloves.
Refer to the hazard label on the VDM100.
Section 2 Installation
®
VDM100 Vapor Delivery Module
2-3
Publicidad
