Tele Radio T60 Manual De Instrucciones página 164

PROGRAMMING THE RECEIVER T60RX-0XYSL
The receiver's function and select buttons are used to program the receivers.
The function button is used to scroll through the different program options.
The select button is used to confirm the selection of the program option.
In the first position it is possible to move between the following options by
pressing the function button.
RED Diode (no. 6)
YELLOW Diode (no. 7) - Setting the momentary/latched relay function
GREEN Diode (no. 8)
When one of the above program options has been selected by using the
select button, the function button is used to move to the relay/relays to be
programmed.The red diodes above the relays indicate which relay/relays are
selected. Refer to respective programming sequences.
SELF-INSTRUCTION OF THE TRANSMITTER'S CODE
Adjustable code
Ensure that the required adjustable code is set on the transmitter's code
switch.
1. Select the program option "Self-instruction of code" (RED diode) using
the function button.
2. Confirm using the select button.The red diodes above the relays light.
3.It is possible, by using the function button, to scroll to the relay/relays
to be coded.
- When an individual relay is selected it will be controlled by the trans-
mitter button used during instruction.
- When all relays are selected the system will function as normal.That
is say, the transmitter's first button will control relay 1, button 2 will
control relay 2, etc.
4. Confirm that the adjustable code is to be programmed by pressing the
select button once.
5. Program the transmitter's code by holding down the appropriate trans-
mitter button until the red diode no. 6 flashes three times.
164
- Learning the transmitter's code
- Setting the interlock function