Tele Radio T60 Manual De Instrucciones página 186

5. Program the transmitter's code by holding down the desired transmitter
button until red LED no. 6 flashes three times.
Red LED (no. 6) flashes to indicate that the transmitter's adjustable code has
been stored.
Adjustable code and fi xed individual code
1. Use the function button to select the "learn code" program alternative
(RED LED).
2. Confirm the selection with the select button.The red LEDs above the
relays light.
3. Using the function button, it is possible to step through to the relay or
relays to be coded.
- If a single relay is selected, it will be controlled by the transmitter
button used during the learning process.
- If all relays are selected, the system will exhibit normal functionality.
That is, the transmitter's first button is to control relay 1, button 2 is to
control relay 2, and so on.
4. Confirm that an adjustable code and fixed individual code are to be
learnt in the following manner:
- Press the select button and release it after 0.3 - 4 seconds.
- Press the select button again within 1 second and hold it down for at - Press the select button again within 1 second and hold it down for at
least 1 second.
5. Learn the transmitter's code by holding down the desired transmitter
button until red LED no. 6 flashes three times.
Red LED (no. 6) double-flashes to indicate that the transmitter's adjustable
and fixed individual codes have been stored.
Erase codes
1. Select the "learn code" program alternative (RED LED).
2. Confirm the selection with the select button.The red LEDs above the
relays light.
3. Using the function button, step through to the relay or relays to be
erased.
4. Hold down the select button until the LED(s) above the relay(s) goes
(go) out (at least 6 seconds.)
186