1. P P u u m m p p a a n n d d M M o o t t o o r r A A s s s s e e m m b b l l y y : : Refer to the Franklin Electric AIM Manual for pump, pipe, and cable

sizing information.

2. C C h h e e c c k k V V a a l l v v e e

3. P P r r e e s s s s u u r r e e R R e e l l i i e e f f V V a a l l v v e e : :

CAUTION

Risk of bodily injury or property damage.

•

Pumps can develop very high pressure in some situations. Always install a pressure re-

lief valve able to pass full pump flow up to 300 psi.

•

Install the pressure relief valve near the pressure tank and route to a drain capable of

full system flow.

4. P P r r e e s s s s u u r r e e T T a a n n k k : : Refer to

5. P P r r e e s s s s u u r r e e G G a a u u g g e e

6. P P r r e e s s s s u u r r e e T T r r a a n n s s d d u u c c e e r r o o r r S S e e n n s s o o r r : : Install in a vertical position after the pressure tank, and within 6 ft

(1.8 m) of the tank to minimize pressure fluctuations. There should be no elbows between the tank

and sensor.

7. S S u u b b D D r r i i v v e e C C o o n n n n e e c c t t P P l l u u s s V V F F D D

8. P P o o w w e e r r S S u u p p p p l l y y f f r r o o m m E E l l e e c c t t r r i i c c a a l l P P a a n n e e l l : : Single phase (shown) 208/230 VAC ± 10%, three phase 230

VAC ±10%, or three phase 460 VAC ±10% (depending on drive model rating).

9. P P o o w w e e r r t t o o M M o o t t o o r r : : Three-Phase voltage depending on drive model rating.

"Minimum Pressure Tank and Supply Pipe Sizing" on page

14.

Tabla de Contenido