Programming Defaults - Franklin Electric SDCP-SUB0723 Manual Del Usuario

SPECIFICATIONS

Programming Defaults

Programming Defaults
Default
Parameter
Value
Submersible
(w/ dV/dt
Motor Type filter)
Centrifugal
(w/o filter)
Motor
1.0
Current
Sensor Type Transducer
Sensor
200
Range
Pressure
0
Setpoint 1
Pressure
0
Setpoint 2
Keypad
60
Frequency
Drawdown 5
High
Frequency 60
Limit
Low Fre-
SUB: 30
quency
CEN: 15
Limit
Carrier
SUB and
Frequency
CEN: 2.5
System
Slow
Response
PID P-Gain 500
54
Range
Units
• Submersible
• Centrifugal
N/A
• FE MagForce
By Frame Size and
Amps Number of input
phases
• Transducer
N/A
• Pressure
Sensor
PSI 100 to 300
5 to (Sensor
PSI
Range – 5)
5 to (Sensor
PSI
Range – 5)
Low Frequency
Limit to High Fre-
Hz
quency Limit
5 to 20 (or pres-
sure setpoint
PSI
whichever is less)
(Low Frequency
Hz
Limit + 1) to 60
Default to (High
Frequency Limit -
Hz
1)
• SUB: 2.5
kHz
• CEN: 2.5 or 8
• Slow
N/A
• Medium
• Fast
N/A 0 to 999
Set Parameter Via:
Program- Mobile
DIP
ming App
Switch
No Yes Yes
No Yes Yes
No Yes Yes
No Yes Yes
No Yes Yes
No Yes Yes
No Yes Yes
No Yes Yes
No No Yes
No No Yes
Yes No Yes
No Yes Yes
No No Yes
Change
while Description
Running
Sets the motor type as submer-
sible (SUB) or centrifugal (sur-
No
face (CEN))
Set to match motor nameplate
No
current
Transducer or Pressure (Hobbs)
Yes
Switch
Sets the range for the installed
pressure transducer.
Yes
This parameter is hidden for
Pressure Switch sensor type.
Sets the pressure setpoint that
the system will maintain.
Yes
This parameter is hidden for
Pressure Switch sensor type.
Sets the secondary pressure
setpoint that the system will
maintain.
Yes
This parameter is hidden for
Pressure Switch sensor type.
Sets the constant speed at
Yes
which the motor will run.
Sets the pressure drop required
for the system to exit sleep and
Yes
run the motor and pump
Sets the highest frequency that
No
the motor can run
Sets the lowest frequency that
No
the motor can run
Adjusts the carrier frequency
when running a surface motor.
Cannot be adjusted if in Sub-
Yes
mersible Mode or on a Submer-
sible (filtered) model.
Adjusts how quickly the system
Yes responds to changes in pressure
and flow
Parameter used to specifically
change the P-Gain of the PID
Yes
loop