4
17. Disconnect the HFM electrical connector and USB ca
ble (if equipped).
18. Connect the factory wiring harness connector (2) to
the HFM overlay harness connector (1).
19. If equipped with USB, connect the factory USB con
nector (4) to the USB extension harness connector
(3).
20. Route the overlay harness and extension cable along
the existing harness to the radio.
21. Using the supplied tie straps, secure the overlay wiring
harness and USB extension cable so that the wires will
not cause any noise or chafing.
22. Position the glove box bin (1) into the vehicle.
23. Turn the glove box bin sideways and install the sup
port strap and retainer assembly (2) onto the outboard
end of the bin.
Jun 03, 2011
K6861338