Mopar 82212906 Manual De Instrucciones página 43

23. Disconnect the electrical connector from the Hands
Free Module (HFM) (1).
24. If equipped with a USB cable, disconnect the USB
connector from the HFM.
25. Connect the factory wiring harness connector (2) to
the HFM overlay harness connector (1).
26. If equipped with USB, connect the factory USB con­
nector (4) to the USB extension harness connector
(3).
27. Route the overlay harness and extension cable along
the existing harness to the radio and secure with the
provided tie straps.
28. The HFM is located below the radio so there will be
excess wire for the extension harness and USB ex­
tension cable. Loop the excess wire and secure it to
prevent any noise or chafing.
29. Position the radio to the instrument panel.
30. Connect the AM/FM antenna (2).
31. Connect the factory electrical connector (1) and the
connector from the supplied wiring harness that was
routed from the HFM.
32. Connect the satellite/navigation antenna (3).
33. If equipped, connect the USB connectors (4), includ­
ing the one that was routed from the HFM.
34. Install the radio mounting screws.
Jun 03, 2011
5
K6861338